Icom ID-4100 HAM Mic + Anytone AT-D878UV Radio Holder with 20mm 67 Designs Ball
Do you struggle to have your Icom mic and your Anytone radio securely attached and close at hand?
Here is what many call the best Jeep accessory for your 67 Designs Arm mounted in your vehicle.
Benefits
- Easy to install with no permanent modification to your Jeep.
- Close to reaching yet out of your way.
- Provides a vertical orientation for your handheld radio's antenna to clear the dashboard for optimal reception.
- The radio can be inserted in and taken out in an instant while using just one hand.
- Expandable system - additional rails for other radios and devices are available for purchase on our site if you decide to change your device.
- All our 67 Designs mounts include a free set of Lateral Support Wings.
- A 20mm Genuine 67 Designs Ball is included and pre-fitted to the mount.
- All our designs are rigorously and extensively real-life tested off-road.
- Mount installs in 10 seconds or less installation.
- Safer than other mounts on the market - made of durable plastic - not tin.
- No sharp metal edges that can scratch a pet (or a passenger) bouncing around on that awful back washboard on your way to Monument Valley.
- Made in the USA! All our products are proudly designed and manufactured in sunny Arizona.
Fitment
- Works with any vehicle with a 67 Designs CF set-up.
- We also have RHD (right-hand drive) versions available. To request just send us a note.
The Mic holder for this model:
- Perfect fit for your Icom ID-4100 Mic.
- Supports any mic for ICOM Handheld Radio using a Square Hole Attachment Point.
- Note that some product images might display other Mobile Mic. However the Mic holder is identical.
The Radio support rail (aka the Vertical Support Rail):
- Custom made to fit the Anytone AT-D878UV's belt clip.
- Rails for other radios are available for purchase on our site if you decide to change your device.
- The mount is not compatible with extended batteries that either:
- Make the radio too long such that it interferes with the mount.
- Extend the depth of the device too much such that the unit cannot be secured to the mount.
- Increase the weight of the device by more than 3oz.
- See this article for a better solution
- Since there is no standard belt-clip design we can not guarantee fit for any other devices.
- Depending on the model of your radio we include special spacers to ensure a secure and rattle-free fit.
- Note that some product images might display other Handheld Radio. However the Radio rail is similar but is specific for your device.
Other Notes
- A 20mm Genuine 67 Designs Ball is included and pre-fitted to the mount.
- Note that some product images might display a 1 inch RAM ball set-up. The mount is similar except for using a 20mm 67 Designs ball instead of the RAM one
Installation:
- No tools needed.
- Attach the mount's 20 mm ball to your 67 Designs Carbon Fiber arm.
Important Notes:
- Our products are for off-road use only.
- Our mounts are only designed for light accessories as stated under the Compatibility notes.
- Do NOT modify or overload the mounts with accessories not listed as supported by JeepUniq.
- Obey your local state and federal laws
- JeepUniq is not responsible for any improper or illegal use of our accessories.
- Vehicle's owner is responsible for ensuring that mounts are not in the way of the airbags.
- Note that some product images might display a 1 inch RAM ball set-up. The mount is similar except for using a 20mm 67 Designs ball instead of the RAM one