sturdy and fits perfectly. As often I struggled and the factory supplied video showed me that having a panel tool helps fitting the handle under the radio mount. Excellent quality and equally fantastic customer service! Thanks to Brad from Trailrecon I found the perfect Jeep mount!
Went on my very first off roading adventure and this holder did amazing! Very very happy with it! My ham radio didn’t move. Very easy to install!
slow to deliver the product, but design, quality function make it worth the wait.
Item looks and works exactly as described. Definitely worth the addition to the Jeep
The upper part works well for a BTECH GMRS handheld radio (or a Baofeng UV82 ham radio). The lower part works OK for an ICOM microphone but it hangs low, close to passenger knees. Because it's so low, there is a lot of leverage that could break the microphone or the mount if hit by a knee. Looks as if it would not be difficult to raise the microphone mount an inch or so. It would be a big improvement.
The holder for our Baofeng handheld is perfect for our Jeep Rubicon.
Great little mount to hold my UV-5R handheld radio. My buddy saw my mount and liked it so much he ordered one for his handheld. You don’t have to drill or disassemble anything for installation which is very nice. My only complaint would be they are a bit pricey.
Amazingly secure, perfect, thanks for making them.
Design and function are great, but clip-on material too bridle and broke during installation. Planning on purchasing a new one... Yes from JeepUnique, because of its design/function and because I haven’t found a comparable product elsewhere. For now using gaffer tape to keep it together to use on an upcoming road trip. If not for the bridle material for clip-on, I’d rate it five stars.
Product: Radio Holder Clip-on for Baofeng BF-S112 HAM Mic + BF-F8HP Radio
Side note: A grab bar mount for two HAM Radios and one Mic would be fantastic.
Cobra 75 WX CB Mic Holder for Jeep JK 11-18 Grab Bar
This product delivers exactly as promised. No disassembly of the vehicle, and holds both units perfectly.
Great quality and great design
It was a very quick install. You will need a deep 8mm socket and an extension as well to remove and replace the two 8mm screws. The mount holds both the CB mike and the Baofeng radio securely. It is easily reachable while driving. This product solved two problems. Highly recommended.
Super fast shipping
easy install... looks very clean in the Jeep
Great solution to mounting coms. I have a two radio solution. Looks “right” when installed. Great to have my radios up and out of the way. Very clean.
Well constructed! My Midland MXT275 mic and Baofeng BF-F8HP handheld fit perfectly with this mount. I highly recommend this product!
Great quality and easy to mount in your Jeep. It almost jumps out of your hand and mounts it self. Haha
American, oem quality. This is my second purchase from them. 10/10 recommend and truly looks factory.
I was impressed with how sturdy this part was. It was easy to install. Everything lined up well. Everything was going well until I tried to hang the mic. Not JeepUniq's fault, but when I ordered this part, I forgot that I had an aftermarket microphone. The holder was a tad too thick for my mic to snap in properly. I resolved the issue by shaving off just a small amount of material from the face of the mic holder with a flat file. Works like a champ now. I would definitely recommend this accessory.
Could not be happier with the mount, ease of install (10 seconds!) and general smoothness of the transaction and high level of customer service. Thanks!
Solid product. Gives your jeep a good look
Uniden PRO520 CB Mic + Baofeng UV-5R Radio Holder for Jeep JK 07-10 Grab Bar