All our JeepUniq Combo Mounts are modular and accept additional Vertical Rails to fit whatever new HAM or SATCOM device you might acquire.
All our JeepUniq Combo Mounts are modular and accept additional Vertical Rails to fit whatever new HAM or SATCOM device you might acquire.
The Jeep Gladiator and the Jeep JL share the same grab bars, so the JL mounts will work on both.
Due to the JK's interior redesign in 2010, we had to split the JK in pre and post redesign models.
For other Jeep models and years, as well as other vehicle brands, such as Toyotas or Land Rovers, our 67 Designs or RAM Compatible ball mounts are a great solution.
The Jeep Gladiator and the Jeep JL share the same grab bars, so the JL mounts will work on both.
Due to the JK's interior redesign in 2010, we had to split the JK in pre and post redesign models.
For other Jeep models and years, as well as other vehicle brands, such as Toyotas or Land Rovers, our 67 Designs or RAM Compatible ball mounts are a great solution.
M-K18JL-B-M1-30247
We have the perfect mount custom made for your Jeep Wrangler JL
I am very happy with my choice of going with JeepUniq. Super easy instal and great customer service.
I made a few awkward attempts at mounting my cb mic but nothing really worked... it either didn’t hold well enough or held too well and I had trouble taking it off. Looked into actual no-kidding cb mounts and JeepUniqs came highly suggested. Really happy all with this mount. Easy to install, extremely durable and easy to take the mic on and off. Oh and also - the customer support from these folks is through the roof top notch. You really can’t get any better!
Products are well designed, sturdy and capable of a few fit adjustments for HT height and width size variation. Designed to restrict side-to-side movement for rough terrain. I feel comfortable that this grab bar holder will work out well.
Perfect mount for permanent or occasional CB radio use. I highly recommend it.
Good design, easy install, unknown if the product would survive numerous removals from the grab bar, when the opening is spread to go around the bar, there was subtle creaking of the plastic and I thought for a moment that it would snap. I held my breath as I slipped it over the bar. I like the snug tight fit and it required a pair of pliers to get it closed enough to slip the locks on. The only down side is the the Midland 75-820/822 radio fits well on the lower belt clip ring but the radio does not fit using the upright belt clip insert as the insert is too short and the 12v adapter does not clear the top of the base, the belt clip of the radio doesn't secure the radio to the mount. If the insert was taller it would work much better. A bit pricey for what it is, but is still usable.