Icom IC-2730 HAM Mic + Garmin Mini InReach SATCOM Holder with 20mm 67 Designs Ball

You just found the most versatile yet custom made mount for your 67 Designs Arm mounted in your vehicle.

Benefits

• Easy to install with no permanent modification to your Jeep.
• Close to reaching yet out of your way.
• Expandable system - additional rails for other radios and devices are available for purchase on our site if you decide to change your device.
• Provides a vertical orientation for your satcom's antenna to clear the dashboard for optimal reception.
• The satcom can be inserted in and taken out in an instant while using just one hand.
• All our 67 Designs mounts include a free set of Lateral Support Wings.
• A 20mm Genuine 67 Designs Ball is included and pre-fitted to the mount.
• All our designs are rigorously and extensively real-life tested off-road.
• Mount installs in 10 seconds or less installation.
• Safer than other mounts on the market - made of durable plastic - not tin.
• No sharp metal edges that can scratch a pet (or a passenger) bouncing around on that awful back washboard on your way to Monument Valley.
• Made in the USA! All our products are proudly designed and manufactured in sunny Arizona.

Fitment

• Works with any vehicle with a 67 Designs CF set-up.
• We also have RHD (right-hand drive) versions available. To request just send us a note.

The Mic holder for this model:

• Perfect fit for your Icom IC-2730 Mic.
• Supports any mic for ICOM Handheld Radio using a Square Hole Attachment Point.
• Note that some product images might display other Mobile Mic. However the Mic holder is identical.

The SATCOM support rail (aka the Vertical Support Rail):

• The rail is custom made for the Garmin Mini InReach.
• The Garmin SATCOMcan easily slides in an out.

Other Notes

• A 20mm Genuine 67 Designs Ball is included and pre-fitted to the mount.
• This mount works with the original Garmin Mini, as well as with the new Garmin Mini Version 2. However Garmin has eliminated an accessory that was included with the original Mini. You'll need to order this part from them (or REI/Amazon/etc): Spine Mount Adapter with Carabiner

Installation:

• No tools needed.
• Attach the mount's 20 mm ball to your 67 Designs Carbon Fiber arm.

Important Notes:

• Our products are for off-road use only.
• Our mounts are only designed for light accessories as stated under the Compatibility notes.
• Do NOT modify or overload the mounts with accessories not listed as supported by JeepUniq.
• Obey your local state and federal laws
• JeepUniq is not responsible for any improper or illegal use of our accessories.
• Vehicle's owner is responsible for ensuring that mounts are not in the way of the airbags.
• Note that some product images might display a 1 inch RAM ball set-up. The mount is similar except for using a 20mm 67 Designs ball instead of the RAM one